Daewoo DWLED-48FHDS: no puedo salir de Aging mide
Publicado: 21 Sep 2018, 01:19
Buenas tengo un led Daewoo dwled-48fhds que no puedo salir del model aging agradecido cualquier ayuda
Menu Fábrica:
Utilizando el control remoto, entre en "imagen", seleccione la opción contraste y presione la secuencia 9->7->3->5.
Following TCL standard and practices, it’s required minimum 15min of Warm-Up that can be
considered as Burn-In.
Additional Aging for White Balance alignment is no more necessary due to consistent Picture
Performance with Cloning usage.
This function is accessible by selecting “Factory menu; WARM-UP”, pressing key board
“menu” key and then leaving Factory menu. Other faster methods are available on above
enclosed SIACP requirements (rev. v3.9).
fijate dentro del menu service si aparese modo aging o tofac